3com S7906E Guide De Référence

 

1-14 

[Sysname] dot1x quiet-period 

dot1x retry max-retry-value 

undo dot1x retry 

System view 

2: System level 

max-retry-value: Maximum number of attempts to send an authentication request to a supplicant, in the 

range 1 to 10. 

Use the dot1x  retry command to set the maximum number of attempts to send an authentication 

request to a supplicant. 

Use the undo dot1x retry command to restore the default. 

By default, the authenticator can send an authentication request to a supplicant twice at most. 

Note that after sending an authentication request to a supplicant, the authenticator may retransmit the 

request if it does not receive any response at an interval specified by the username request timeout 

timer or supplicant timeout timer. The number of retransmission attempts is one less than the value set 

by this command. 

Related commands: display dot1x. 

# Set the maximum number of attempts to send an authentication request to a supplicant as 9. 

<Sysname> system-view 

[Sysname] dot1x retry 9 

In system view: 

dot1x supp-proxy-check { logoff | trap } [ interface interface-list ] 

undo dot1x supp-proxy-check { logoff | trap } [ interface interface-list ] 

In Ethernet interface view:  

dot1x supp-proxy-check { logoff | trap } 

undo dot1x supp-proxy-check { logoff | trap }