3com S7906E Guide De Référence

 

1-17 

z 

Using the undo portal server server-name command, you remove the specified portal server if 

the specified portal server exists and there is no user on the interfaces referencing the portal 

server. 

z 

The configured portal server and its parameters can be removed or modified only when the portal 

server is not referenced by an interface.   

z 

To remove or modify the settings of a portal server that has been referenced by an interface, you 

must remove the portal configuration on the interface using the undo portal command. 

Related commands: display portal server. 

# Configure portal server pts, setting the IP address to 192.168.0.111, the key to portal, and the 

redirection URL to http://192.168.0.111/portal. 

<Sysname> system-view 

[Sysname] portal server pts ip 192.168.0.111 key portal url http://192.168.0.111/portal 

portal server server-name method { direct | layer3 | redhcp } 

undo portal 

Interface view 

2: System level 

server-name: Name of the portal server, a case-sensitive string of 1 to 32 characters. 

method: Specifies the authentication mode to be used. 

direct: Direct authentication. 

layer3: Layer 3 authentication. 

redhcp: Re-DHCP authentication. 

Use the portal server command to enable portal authentication on an interface, and specify the portal 

server to be referenced and the authentication mode. 

Use the undo portal command to disable portal authentication on an interface. 

By default, portal authentication is disabled on an interface. 

Note that: The portal server to be referenced must exist.   

Related commands: display portal server. 

# Enable portal authentication on interface VLAN-interface 100, setting the portal server to pts, and 

the authentication mode to direct.