3com S7906E Guide De Référence

 

1-10 

[Sysname-vlan2] port GigabitEthernet 2/0/1 to GigabitEthernet 2/0/3 

# Assign Layer-2 aggregate interface Bridge-aggregation 1 to VLAN 2.  

<Sysname> system-view 

[Sysname] vlan 2 

[Sysname-vlan2] port bridge-aggregation 1 

port access vlan vlan-id 

undo port access vlan 

 Ethernet interface view, port group view, Layer-2 aggregate interface view, 

2: System level 

vlan-id: VLAN ID, in the range of 1 to 4094. Be sure that the VLAN specified by the VLAN ID already 

exists. 

Use the port access vlan command to assign the current access port(s) to the specified VLAN.  

Use the undo port access vlan command to restore the default. 

By default, all access ports belong to VLAN 1. 

You can assign an access port to only one VLAN. When doing that, note the following: 

z 

In Ethernet interface view, this command only applies to the current port. 

z 

In port group view, this command applies to all ports in the port group. For information about port 

groups, refer to Ethernet Interface Configuration in the Access Volume. 

z 

In Layer-2 aggregate interface view, this command applies to the Layer-2 aggregate interface and 

all its member ports. After you perform the configuration, the system starts applying the 

configuration to the aggregate interface and its aggregation member ports. If the system fails to do 

that on the aggregate interface, it stops applying the configuration to the aggregation member ports. 

If it fails to do that on an aggregation member port, it simply skips the port and moves to the next 

port. For information about Layer-2 aggregate interfaces, refer to Link Aggregation Configuration in 

the Access Volume.  

# Assign GigabitEthernet 2/0/1 to VLAN 3. 

<Sysname> system-view 

[Sysname] vlan 3 

[Sysname-vlan3] quit 

[Sysname] interface GigabitEthernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] port access vlan 3