3com S7906E Guide De Référence

 

1-12 

# Configure VLAN 100 as the default VLAN of the hybrid port GigabitEthernet 2/0/1. 

<Sysname> system-view 

[Sysname] vlan 100 

[Sysname-vlan100] quit 

[Sysname] interface GigabitEthernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] port link-type hybrid 

[Sysname-GigabitEthernet2/0/1] port hybrid pvid vlan 100 

# Configure VLAN 100 as the default VLAN of the hybrid Layer-2 aggregate interface 

Bridge-aggregation 1. 

<Sysname> system-view 

[Sysname] interface bridge-aggregation 1 

[Sysname-Bridge-Aggregation1] port hybrid pvid vlan 100 

port hybrid vlan vlan-id-list { tagged | untagged } 

undo port hybrid vlan vlan-id-list 

Ethernet interface view, port group view, Layer-2 aggregate interface view 

2: System level 

vlan-id-list: VLANs that the hybrid ports will be assigned to. This argument is expressed in the format of 

[ vlan-id1 [ to vlan-id2 ] ]&<1-10>, where vlan-id ranges from 1 to 4094 and &<1-10> indicates that you 

can specify up to 10 VLAN IDs or VLAN ID ranges. Be sure that the specified VLANs already exist.  

tagged: Configures the port(s) to send the packets of the specified VLAN(s) with the tags kept. 

untagged: Configures the port to send the packets of the specified VLAN(s) with the tags removed. 

Use the port hybrid vlan command to assign the current hybrid port(s) to the specified VLAN(s). 

Use the undo port hybrid vlan command to remove the current hybrid port(s) from the specified 

VLAN(s). 

By default, a hybrid port only allows packets from VLAN 1 to pass through untagged.  

A hybrid port can carry multiple VLANs. If you execute the port hybrid vlan command multiple times, 

the VLANs the hybrid port carries are the set of VLANs specified by vlan-id-list in each execution. 

z 

In Ethernet interface view, this command only applies to the current port. 

z 

In port group view, this command applies to all ports in the port group. For information about port 

groups, refer to Ethernet Interface Configuration in the Access Volume. 

z 

In Layer-2 aggregate interface view, this command applies to the Layer-2 aggregate interface and 

all its member ports. After you perform the configuration, the system starts applying the