3com S7906E Guide De Référence
1-5
Output information of the tracert command includes IP addresses of all the routers the packets traverse
from the source to the destination device. If a router times out, "* * *" will be displayed.
Examples
# Display the routers the packets traverse from the source device to the destination device with an IP
address of 18.26.0.115.
<Sysname> tracert 18.26.0.115
traceroute to 18.26.0.115(18.26.0.115) 30 hops max,40 bytes packet, press CTRL_C to break
1 128.3.112.1 10 ms 10 ms 10 ms
2 128.32.210.1 19 ms 19 ms 19 ms
3 128.32.216.1 39 ms 19 ms 19 ms
4 128.32.136.23 19 ms 39 ms 39 ms
5 128.32.168.22 20 ms 39 ms 39 ms
6 128.32.197.4 59 ms 119 ms 39 ms
7 131.119.2.5 59 ms 59 ms 39 ms
8 129.140.70.13 80 ms 79 ms 99 ms
9 129.140.71.6 139 ms 139 ms 159 ms
10 129.140.81.7 199 ms 180 ms 300 ms
11 129.140.72.17 300 ms 239 ms 239 ms
12 * * *
13 128.121.54.72 259 ms 499 ms 279 ms
14 * * *
15 * * *
16 * * *
17 * * *
18 18.26.0.115 339 ms 279 ms 279 ms
tracert ipv6
Syntax
tracert ipv6 [ -f first-ttl | -m max-ttl | -p port | -q packet-number | -w timeout ] * remote-system
View
Any view
Default Level
0: Visit level
Parameters
-f first-ttl: Specifies the first TTL, that is, the allowed number of hops for the first packet, in the range 1 to
255. It defaults to 1 and must be less than the maximum TTL.
-m max-ttl: Specifies the maximum TTL, that is, the maximum allowed number of hops for a packet, in
the range 1 to 255. It defaults to 30 and must be greater than the first TTL.
-p port: Specifies the UDP port number of the destination device, in the range 1 to 65535. The default
value is 33434. It is unnecessary to modify this parameter.
-q packet-number: Specifies the number of probe packets sent each time, in the range 1 to 65535,
defaulting to 3.