3com S7906E Guide De Référence

 

1-17 

address of the specified interface. If you want to display the source IP address in the log information, 

you can configure it by using this command. 

Note that: 

z 

The  info-center loghost source command takes effect only after the information center is 

enabled with the info-center enable command. 

z 

The IP address of the specified source interface must be configured; otherwise, although the 

info-center loghost source command can be configured successfully, the log host will not receive 

any log information. 

# Configure interface VLAN-interface 1 as the egress interface to output log information to the log host. 

<Sysname> system-view 

[Sysname] info-center loghost source Vlan-interface 1 

info-center monitor channel { channel-number | channel-name } 

undo info-center monitor channel 

System view 

2: System level 

channel-number: Specifies a channel number, in the range 0 to 9. 

channel-name: Specifies a channel name, which could be a default name or a self-defined name. The 

user needs to specify a channel name first before using it as a self-defined channel name. For more 

information, refer to the info-center channel name command. 

Use the info-center monitor channel command to configure the channel to output system information 

to the monitor. 

Use the undo info-center monitor channel command to restore the default channel to output system 

information to the monitor. 

By default, output of system information to the monitor is enabled with a default channel name of 

monitor and a default channel number of 1. 

Note that the info-center monitor channel command takes effect only after the information center is 

enabled with the info-center enable command. 

# Set to output system information to the monitor through channel 0. 

<Sysname> system-view