3com S7906E Guide De Référence
2-41
If a UNI port of an ET254-L ONU is added to an isolation group, the operation mode of the UNI port
can be set to the transparent transmission mode only, but not VLAN tag mode or VLAN Translation
mode.
If all ONU ports under an OLT port are access ports, to make sure that the packets received on the
ONU port and PC are untagged packets, the VLAN operation mode of a UNI can only be
configured as the transparent mode.
Examples
# Configure the VLAN operation mode of UNI 1 as VLAN transparent transmission mode.
<Sysname> system-view
[Sysname] interface onu 1/0/1:1
[Sysname-Onu1/0/1:1] uni 1 vlan-mode transparent
upstream-sla
Syntax
upstream-sla { minimum-bandwidth value1 | maximum-bandwidth value2 | delay { low | high } } *
undo upstream-sla
View
ONU port view
Default Level
2: System level
Parameters
minimum-bandwidth value1: Specifies the minimum uplink bandwidth, in the unit of 64 kbps. value1 is
in the range 8 to 14400 and defaults to 32.
maximum-bandwidth value2: Specifies the maximum uplink bandwidth, in the unit of 64 kbps. value2
is in the range 8 to 16000 and defaults to 368.
delay: Specifies the delay mode. The low keyword means that low delay is adopted and the high
keyword is high delay. Low delay is adopted by default.
Description
Use the upstream-sla command to set the ONU's minimum uplink bandwidth, maximum uplink
bandwidth, and delay mode of packet forwarding through the EPON system.
Use the undo upstream-sla command to restore the default values.