3com S7906E Guide De Référence

 

1-14 

Use the network command to enable RIP on the interface attached to the specified network. 

Use the undo network command to disable RIP on the interface attached to the specified network. 

Use the network 0.0.0.0 command to enable RIP on all interfaces. 

RIP is disabled on an interface by default. 

Note that: 

z 

RIP runs only on the interfaces attached to the specified network. For an interface not on the 

specified network, RIP neither receives/sends routes on it nor forwards interface route through it. 

Therefore, you need to specify the network after enabling RIP to validate RIP on a specific 

interface. 

z 

For a single process, you can use the network 0.0.0.0 command to enable RIP on all interfaces, 

while the command is not applicable in case of multi-process.  

z 

If a physical interface is attached to multiple networks, you cannot advertise these networks in 

different RIP processes. 

# Enable RIP on the interface attached to the network 129.102.0.0. 

<Sysname> system-view 

[Sysname] rip 100 

[Sysname-rip-100] network 129.102.0.0 

output-delay time count count 

undo output-delay 

RIP view 

2: System level 

time: RIP packet sending interval, in milliseconds. It is in the range 10 to 100.  

count: Maximum number of RIP packets sent at each interval. It is in the range 1 to 20. 

Use the output-delay  command to configure the maximum RIP packets that can be sent at the 

specified interval for all interfaces under the RIP process.  

Use the undo output-delay command to restore the default.  

By default, an interface sends up to three RIP packets every 20 milliseconds. 

# Configure all the interfaces under RIP process 1 to send up to 10 RIP packets every 30 milliseconds.