3com S7906E Guide De Référence

 

1-39 

Use the isis cost command to set the IS-IS cost of an interface.  

Use the undo isis cost command to restore the default.  

No cost is configured by default. 

If neither level-1 nor level-2 is included, the cost applies to both level-1 and level-2.  

You are recommended to configure a proper IS-IS cost for each interface to guarantee correct route 

calculation.  

Relate command: circuit-cost. 

# Configure the Level-2 IS-IS cost as 5 for VLAN-interface10.  

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] isis cost 5 level-2 

isis dis-name symbolic-name 

Interface view 

2: System level 

symbolic-name: Specifies a DIS name, a string of 1 to 64 characters.  

Use the isis dis-name command to configure a name for a DIS to represent the pseudo node on a 

broadcast network.  

Use the undo isis dis-name command to remove the configuration.  

No name is configured for the DIS by default. 

Note that this command takes effect only on a router that must have dynamic system ID to host name 

mapping enabled. This command is not supported on a Point-to-Point interface.  

 

This command is not available in loopback interface view.