3com S7906E Guide De Référence

 

1-55 

Use the network-entity command to configure the Network Entity Title for an IS-IS routing process.  

Use the undo network-entity command to delete a NET.  

No NET is configured by default. 

Related commands: isis, isis enable.  

# Specify the NET as 10.0001.1010.1020.1030.00, of which 10.0001 is the area ID and 

1010.1020.1030 is the system ID.  

<Sysname> system-view 

[Sysname] isis 

[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00 

preference { route-policy route-policy-name | preference } * 

IS-IS view 

2: System level 

preference: Specifies the preference for IS-IS protocol, ranging from 1 to 255.  

route-policy route-policy-name: Routing policy name, a string of 1 to 19 characters. The preference 

applies to routes passing the routing policy. 

Use the preference command to configure the preference for IS-IS.  

Use the undo preference command to restore the default.  

By default, IS-IS preference is 15.  

If a routing policy is specified in this command, the preference (if any) set by the routing policy applies to 

those matched routes. Other routes use the preference set by the preference command.  

When a router runs multiple routing protocols at the same time, the system will configure a preference 

to each routing protocol. If several protocols find routes to the same destination, the route of the routing 

protocol with the highest preference is selected.  

# Configure the preference of IS-IS protocol as 25.  

<Sysname> system-view 

[Sysname] isis