3com S7906E Guide De Référence

 

1-66 

Usually, there is only one route reflector in a cluster. The router ID of the route reflector is the ID of the 

cluster. You can configure multiple route reflectors to improve network stability. In this case, using this 

command can configure the identical cluster ID for all the route reflectors to avoid routing loops. 

Related commands: reflect between-clients and peer reflect-client. 

# Set the cluster ID to 80. 

<Sysname> system-view 

[Sysname] bgp 100 

[Sysname-bgp] reflector cluster-id 80 

refresh bgp { all | ip-address | group group-name | external | internal } { export | import } 

User view 

1: Monitor level 

all: Soft-resets all BGP connections.  

ip-address: Soft-resets the BGP connection to a peer.  

group-name: Soft-resets connections to a peer group, name of which is a sting of 1 to 47 characters.  

external: EBGP connection.  

internal: IBGP connection.  

export: Outbound soft reset.  

import: Inbound soft reset. 

Use the refresh bgp command to perform soft reset on specified BGP connections. Using this function 

can refresh the BGP routing table without tearing down BGP connections and apply a newly configured 

routing policy. 

To perform BGP soft reset, all routers in the network must support route-refresh. If a router not 

supporting route-refresh exists in the network, you need to configure the peer keep-all-routes 

command to save all routing updates before performing soft reset. 

# Perform inbound BGP soft reset. 

<Sysname> refresh bgp all import