3com S7906E Guide De Référence

 

1-12 

After you execute this command, the generated RIPng default route is advertised in a route update over 

the specified interface. This IPv6 default route is advertised without considering whether it already 

exists in the local IPv6 routing table. 

# Advertise only the default route through VLAN-interface 100.  

<Sysname> system-view 

[Sysname] interface vlan-interface 100 

[Sysname-Vlan-interface100] ripng default-route only 

# Advertise the default route together with other routes through VLAN-interface 101.  

<Sysname> system-view 

[Sysname] interface vlan-interface 101 

[Sysname-Vlan-interface101] ripng default-route originate 

ripng process-id enable 

undo ripng enable 

Interface view 

2: System level 

process-id: RIPng process ID, in the range of 1 to 65535. 

Use the ripng enable command to enable RIPng on the specified interface. 

Use the undo ripng enable command to disable RIPng on the specified interface. 

By default, RIPng is disabled on an interface. 

# Enable RIPng100 on VLAN-interface 100. 

<Sysname> system-view 

[Sysname] interface vlan-interface 100 

[Sysname-Vlan-interface100] ripng 100 enable 

ripng metricin value 

undo ripng metricin