3com S7906E Guide De Référence

 

1-31 

Interface view 

2: System level 

broadcast: Specifies the network type as Broadcast. 

nbma: Specifies the network type as NBMA. 

p2mp: Specifies the network type as P2MP. 

p2p: Specifies the network type as P2P. 

non-broadcast: Specifies the interface to send packets in unicast mode. By default, an OSPFv3 

interface whose network type is P2MP sends packets in multicast mode. 

instance-id: The instance ID of an interface, in the range of 0 to 255, which defaults to 0. 

Use the ospfv3 network-type command to set the network type for an OSPFv3 interface. 

Use the undo ospfv3 network-type command to restore the default. 

By default, the network type of an interface depends on its link layer protocol. For example: 

z 

For PPP, the default network type is P2P. 

z 

For Ethernet, the default network type is broadcast. 

# Configure the interface’s network type as NBMA. 

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] ospfv3 network-type nbma 

ospfv3 peer ipv6-address [ dr-priority dr-priority ] [ instance instance-id ] 

undo ospfv3 peer ipv6-address [ instance instance-id ] 

Interface view  

2: System level  

ipv6-address: Neighbor link-local IP address. 

dr-priority: Neighbor DR priority, in the range 0 to 255. The default is 1. 

instance-id: Interface instance ID, in the range 0 to 255. The default is 0.