3com S7906E Guide D’Installation Rapide

 

2-5 

z

 

Make sure that the switch fits the rack size. Leave some spaces beside the left and right panels of 
the switch for chassis heat dissipation. 

Required installation tools list 

Measure and 
lineation tools 

Long tape, ruler (of 1 meter), gradienter, marking pen, 
powder marker and pencil 

Drills 

A percussion drill, several auxiliary drill bits, a vacuum 
cleaner 

Fastening tools 

Flat-blade screwdriver P4-75mm 
Phillips screwdriver P1-100mm, P2-150mm and 
P3-250mm 
Socket wrench M5  
Socket wrench M6 
Double offset ring wrench M6 
Double-ended double offset ring wrench (10-12) or double 
open-end wrench (10-12) 

Small tools 

Sharp-nose pliers, diagonal pliers, vices, hand-held 
electrical drill, file, handsaw, crowbar and rubber hammer

General tools 

Auxiliary tools 

Hair brush, tweezers, paper knife, hand bellows, electric 
iron, solder wire, fork and ladder 

Special tools 

ESD-preventive wrist glove, cable stripper, crimping pliers, RJ-45 crimping 
pliers and wire punchdown tool 

Tools for 
fiber-optic 
cleaning  

Lint-free paper, and optical fiber End-Face microscope 

Instruments 

Multimeter, 500 V Meg-ohmmeter (used to measure the insulation resistance), 
error detector, optical power meter and earth resistance tester 

 

The above instruments and tools are not shipped with the S7900E series and need to be prepared by 
the users.