4XEM w30 Manuel D’Utilisation

 

 

 
 

 
 
 

 

 

 

 

 

 

 

 
 

In this manual, "User" refers to whoever has access to the Network Camera, and 
"Administrator" refers to the person who can configure the Network Camera and grant 
user access to the camera. 

 

Please verify that your product package contains all the 
accessories listed in the foregoing Package Contents.  
Depending on the user’s application, an Ethernet cable 
may be needed. The Ethernet cable should meet the specs 
of UTP Category 5 and not exceed 100 meters in length. 
 

Upon powering up, the device runs through a self-test procedure and the front LEDs will 
blink between green and red a few times.    If self-test passes, the LED will be green and 
the Network Camera will standby for getting IP address. After getting IP Address, the LED 
will blink green every second. If self-test fails the red LED will blink several times. Refer 
to Appendix A for troubleshooting. 
 
The Network Camera will first detect Ethernet. If it does not connect to Ethernet, the 
Network Camera will try WLAN. During the searching and connecting process to the 
wireless access point or station, the red LED of the Network Camera will flash every 
second.  Until the Network Camera connects to the other wireless device, the red LED 
will become lighted.    Operating in either network mode, the green LED will flash every 
second as heartbeat to indicate alive. 
 

 Connect the power adapter jack to the Network 

Camera before plugging in to the power socket. This will 
reduce the risk of accidental electric shock.