Xanté aw 1200 Mode D'Emploi

If this is not the first memory upgrade, you must remove the initial upgrade from the
memory bank before installing the new upgrade. When you open the bank latches the
old upgrade pops up automatically; lift it straight up and out of the bank.

5.

Install the new RAM SODIMM (fig. 6.35).

a.

Align the RAM SODIMM straight above its bank, making sure the
SODDIM’s notches are positioned over the corresponding IDE board
connector’s notches.

b.

Lower the SODIMM straight down into its bank until the bank latches
snap into place (fig. 6.35).

Do not force a SODIMM into place. If it does not go in easily, realign it making sure
its notches are positioned correctly; then, lower the SODIMM into place (fig. 6.35).

6.

Reassemble the printer following the procedure in the next section,
“Reassembling the Printer.”

After you install a controller board upgrade, use the following procedure to
reassemble the printer.

1.

Align and lower the controller cover onto the printer (fig. 6.36). Make sure the
cover’s arrow points forward, the five front edge tabs fit into the corresponding
printer slots, and the three screws align with corresponding printer holes.