Xantech 480-95 Manuel De Montage
08905099B
-
11
-
4.
Verify IR Receiver.
Remove the power supply from the
connecting block and all Emitters from
the output. Place a jumper wire on the
connecting block between IR Signal and
GND. Reconnect the Power Supply.
With a known good hand-held remote,
shoot a constant IR Command at the
receiver and verify the TB LED on the
Receiver lights.
connecting block and all Emitters from
the output. Place a jumper wire on the
connecting block between IR Signal and
GND. Reconnect the Power Supply.
With a known good hand-held remote,
shoot a constant IR Command at the
receiver and verify the TB LED on the
Receiver lights.
Xantech Corporation
13100 Telfair Avenue, 2/F
Sylmar, CA 91342
Phone: (818) 362-0353, Fax: (818) 362-9506
Instructions, 480-95 © 2006 Xantech Corporation
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior
written consent from Xantech Corporation.
Xantech Corporation shall not be liable for operational, technical, or editorial errors/omissions made in this document.
Document Number 08905099 Rev B