Xerox 2101 Manuel Complémentaire

Use this option to assign the gateway address automatically for printing with TCP/IP. 
This option appears only if you selected DHCP or BOOTP as the protocol in the 
previous option.

This option appears only if you answered No to Enable Auto IP Configuration.

Enter the Fiery EX2101 IP address for Ethernet. This IP address, unlike an IP address 
set automatically, remains the same if you restart the Fiery EX2101. You must change 
the default to a valid address for your network. For information about setting up 
printing with TCP/IP, see 

.

This option allows you to modify the subnet mask for printing with TCP/IP over 
Ethernet. To set the subnet mask, enter one of the following values:

•

255.0.0.0

 if the IP address starts with a number less than 128

•

255.255.0.0

 if the IP address starts with a number from 128 through 191

•

255.255.255.0

 if the IP address starts with a number greater than 191

Confirm the subnet mask setting with your network administrator before 

proceeding. In some cases, the required setting may be different from that listed.

This option appears only if you answered Get Gateway Address Automatically. 

Use this option to set the gateway address for printing with TCP/IP. If your network 
uses a gateway, you must change the default to a correct gateway address for 
your network.