Xerox 300x Mode D'Emploi

When you have finished checking the test print and entering the 
values, do one of the following:

■

Make a second test print with the new values.  Clicking the Print 
button changes the values in the printer so the test print reflects the 
new values.  The values in the Gray Linearity dialog box are 
displayed as 5, indicating that the grays shown in the center (5) box 
of the test print now show your new settings.  

■

Repeat Steps 3 and 4 for fine-tuning colors if the first adjustment is 
not close enough to what you expected.  The changes in gray levels 
are smaller between boxes near the center than between boxes near 
the ends, allowing you to fine-tune your selection that is now 
shown in the center box.  

■

Click Cancel to leave the last settings in place if you haven’t made 
another test print or clicked OK.

■

Click Restore Defaults to return the values in the dialog box to the 
factory defaults.  Click OK to send the default values to the printer.

■

If you are satisfied with the adjustments, click OK to send the new 
calibration settings to the printer.  Clicking the OK button changes 
the values in the printer.  

If you want to save the new calibration settings to use again, select 
Save Settings; the Save Calibration dialog box opens.