Xerox 6115MFP Mode D'Emploi

Keep the following guidelines in mind:

■

Be careful when cleaning the inside of the product or removing media misfeeds, as the 
fuser and other internal parts may be very hot.

■

Do not place anything on top of the product.

■

Use a soft cloth to clean the product.

■

Never spray cleaning solutions directly on the product’s surface; the spray could penetrate 
through the air vents of the product and damage the internal circuits.

■

Avoid using abrasive or corrosive solutions or solutions that contain solvents (such as 
alcohol and benzene) to clean the product.

■

Always test any cleaning solution (such as mild detergent) on a small inconspicuous area 
of your product to check the solution’s performance.

■

Never use sharp or rough implements, such as wire or plastic cleaning pads.

■

Always close the product’s covers gently. Never subject the product to vibration.

■

Do not leave the product’s covers open for any length of time, especially in well-lit places. 
Light exposure can damage the imaging unit.

■

Do not open the product’s covers during printing.

■

Do not lubricate or disassemble the product.

■

Do not tilt the product while in use.

■

Do not touch the electrical contacts, gears, or laser devices. Doing so may damage the 
product and cause the print quality to deteriorate.

■

Keep media in the output bin at a minimum level. If the media is stocked too high, your 
product may experience media misfeeds and excessive media curl.

■

Make sure any parts removed during cleaning are replaced before you plug in the product.