Xerox 7228 Mode D'Emploi

134 

 

5.  Ensure that the TCP/IP and HTTP protocols are configured on the device and are fully functional.  

This is required to access the multifunction device's CentreWare Internet Services web pages, which 
can be used to configure Server Fax settings from a network-connected workstation. 

To verify that the TCP/IP and HTTP protocols are correctly configured, print a Settings List as stated 
in the Settings List topic in the Network Connectivity section of this guide. 

To configure TCP/IP, refer to the TCP/IP Configuration topic in the NOS Selection section of this 
guide. 

6.  To enable HTTP, refer to the Enable Internet Services (HTTP) topic in the Network Connectivity 

section of this guide. 

7.  Ensure that the FTP Client and SMB port are enabled on the device.  To verify this, print a Settings 

List as stated in the Settings List topic in the Network Connectivity section of this guide. 

To enable SMB, refer to Enabling the SMB Setting at the Device in the Microsoft (NetBIOS over IP) 
Networks topic of this guide.  To enable FTP, use the same SMB enabling procedure, and simply 
choose FTP as the port to enable. 

8.  Install and configure the Xerox-certified, third party fax server per the fax management software 

manufacturer's instructions. 

Note:  If the fax server will be using TCP/IP to communicate, it is recommended that the server be 
assigned a static IP address.