Gestetner 1302 Mode D’Emploi
Canceling a Memory Transmission
19
2
Canceling a Memory Transmission
Before the Start Key is Pressed
AAAA
Press the
{{{{Clear Modes}}}} key.
Note
❒ When you set the document in
the Document Feeder, you can
cancel the transmission by just
removing it.
cancel the transmission by just
removing it.
While the Original is Being
Scanned
Scanned
AAAA
Press the
{{{{Clear/Stop}}}} key.
The machine will stop storing the
original and the data will not be
sent.
original and the data will not be
sent.
During Transmission
Use this procedure to cancel a trans-
mission after the original has been
scanned.
mission after the original has been
scanned.
Limitation
❒ If transmission finishes while you
are carrying out this procedure, it
will not be canceled.
will not be canceled.
Note
❒ If you cancel a message while it is
being sent, transmission is halted
as soon as you finish this proce-
dure. However, some pages of
your message may have already
been sent and will be received at
the other end.
as soon as you finish this proce-
dure. However, some pages of
your message may have already
been sent and will be received at
the other end.
AAAA
Make sure that the machine is in
Facsimile mode and the standby
display is shown.
Facsimile mode and the standby
display is shown.
BBBB
Press the
{{{{Job Information}}}} key,
and confirm that " 1. Cancel TX /
RX " is displayed.
RX " is displayed.
The Information menu is shown.