Gestetner ao70 Mode D’Emploi

Copy Paper

17

❒ Please use recommended paper. Although you can use other copier paper, if

it matches the paper specifications.

⇒ p.12 “Anti-humidity Heater Switch”

• If the humidity level is high, and the roll paper has expanded due to the mois-

ture, make sure to cut off approximately 1000mm, (40") before making copies.

• Use roll paper that has a black core.
• When a paper roll of 90g/m

2

 (24 lb) or 110g/m

2

 (29.3 lb) paper is used and

not much paper is left on the roll, copies may be faint near the leading and/
or trailing edge, or an image may be doubled. To prevent this, set 3-5mm,
(0.11"-0.19") margins from the leading and trailing edges.

Smooth out any curl in the paper before using it.
When loading translucent paper, load it lengthways, whenever possible.

When using hemmed paper, wrinkles and other problems may occur in your
copies. Use the following procedure when copying onto hemmed paper.
• Make the copy using the bypass tray.
• Make sure that the paper is straight, and align the paper guides of the bypass

tray with the paper size.

• Load only one sheet at a time.
• Remove each copy from the output tray and place it on a flat surface.
• Store opened paper in a plastic bag so that it will not become damp.

❒ Due to the thickness of hemmed paper, the copies may be faint, blurred, pa-

per may wrinkle, or paper jams may occur. You may be able to prevent this
by copying on the rear surface of the paper or feeding the bottom of the paper
in first.

DolphinGB-Copy-F_V4_FM.book  Page 17  Monday, June 11, 2001  5:02 PM