Gestetner ao70 Mode D’Emploi
Basic Procedure
29
2
Note
❒ Insert the originals so that the
right edge is aligned with the
original guide.
original guide.
❒ Release the original when it is
pulled slightly into the ma-
chine.
chine.
❒ Immediately after the machine
is turned on, or if the tempera-
ture is low, or if making a lot of
continuous copies (more than
30 sheets/A0, (more than 30
sheets/E size)), the continuous
copy speed may be down to en-
sure the toner fuses to the pa-
per. This is called CPM down.
ture is low, or if making a lot of
continuous copies (more than
30 sheets/A0, (more than 30
sheets/E size)), the continuous
copy speed may be down to en-
sure the toner fuses to the pa-
per. This is called CPM down.
❒ To stop originals being fed into
the machine, press the
{Scanner
Stop
} key.
❒ When you press the {Scanner
Stop
} key, the original stops im-
mediately, which can cause the
original to jam. If this happens,
see p.116 “
original to jam. If this happens,
see p.116 “
xClearing Mis-
feeds”
❒ To pause or cancel a copy job,
press the
{Clear/Stop} key.
When you press the
{Clear/Stop}
key, the machine stops after the
current copy (one sheet) has fin-
ished.
current copy (one sheet) has fin-
ished.
Reference
⇒ p.31 “Setting Originals”
⇒ p.21 “Paper Capacities For
Each Original/Paper Output”
⇒ p.21 “Paper Capacities For
Each Original/Paper Output”
G
The machine starts copying.
Note
❒ When Scanner Stop Trigger set-
ting is set to on, copying starts
when you press the
when you press the
{Start} key.
See p.128 “Print Start Trigger”
Original Counter/Reset
A f t e r t h e o r i g i n a l s h a v e b e e n
scanned, the number of originals is
displayed in the right corner of the
screen. This allows you to check the
number of originals in a job, or to
check if any sheets have been fed to-
gether, and can also be used as a
guide for the number of copies that
will be stored in the copy output tray.
scanned, the number of originals is
displayed in the right corner of the
screen. This allows you to check the
number of originals in a job, or to
check if any sheets have been fed to-
gether, and can also be used as a
guide for the number of copies that
will be stored in the copy output tray.
Resetting the original counter
A
Press the [Orig.] key and the count
number in the top right corner of
the screen.
The number is reset to 0.
number in the top right corner of
the screen.
The number is reset to 0.
ZEDH150E
DolphinGB-Copy-F_V4_FM.book Page 29 Monday, June 11, 2001 5:02 PM