Gestetner ao80 Mode D’Emploi
Basics
10
1
DDDD
After the original has been eject-
ed, pull the document roller for-
ward and remove the original.
ed, pull the document roller for-
ward and remove the original.
Adjusting the Original Tray
When using the optional original
tray, adjust the hook position to the
size of the original.
tray, adjust the hook position to the
size of the original.
Copy Output Locations
The following copy output locations
are available.
are available.
❖
❖
❖
❖ Front Output
When [Front] is selected, copies are
sent to the copy output tray at the
front of the machine. When copy-
ing sizes up to A1 (D)
sent to the copy output tray at the
front of the machine. When copy-
ing sizes up to A1 (D)
L, select
front output.
If the output copies are badly
curled, turn the paper loaded in
the cut paper trays upside down,
or remove the copies during the
copy run.
If the output copies are badly
curled, turn the paper loaded in
the cut paper trays upside down,
or remove the copies during the
copy run.
❖
❖
❖
❖ Rear Output
When [Rear] is selected, copies are
sent to the copy output tray at the
back of the machine.
When copying A1 (D)
sent to the copy output tray at the
back of the machine.
When copying A1 (D)
K or A0
(E)
K, select rear output.
Front output
AAAA
Press [Front] under Copy Output
Location.
Location.
Rear output
AAAA
Press [Rear] under Copy Output
Location.
Location.
Note
❒ When copying onto thick paper,
the last sheet to be ejected may
remain in the exit area. If this
happens, remove it.
remain in the exit area. If this
happens, remove it.
ZEDP071E
DolphinC2_ENcopy_F_FM.book Page 10 Friday, February 25, 2005 10:46 AM