Gestetner ao80 Mode D’Emploi
Basics
16
1
❒ When inserting long length orig-
inals, there may be some move-
me nt t o e it her side. If thi s
happens, correct the movement
manually while feeding the
originals into the machine.
me nt t o e it her side. If thi s
happens, correct the movement
manually while feeding the
originals into the machine.
CCCC
Press the
{{{{#}}}} key after all origi-
nals have been scanned.
-
-
-
-To stop originals feeding in
If the originals are feeding in slanted,
or jamming, etc., press the
or jamming, etc., press the
{{{{Scanner
Stop
}}}} key to stop them feeding in.
Note
❒ When you press the {{{{Scanner Stop}}}}
key, the original stops immediate-
ly, which can cause it to jam. If this
happens, see “
ly, which can cause it to jam. If this
happens, see “
xClearing Mis-
feeds”, General Settings Guide.
❒ When you have set rear original
exit as the original output location,
the rear edge of the originals are
held at the output exit. To cancel
this, press the
the rear edge of the originals are
held at the output exit. To cancel
this, press the
{{{{Scanner Stop}}}} key.
See p.8 “Original Output Loca-
tions”.
tions”.
Original Orientation
Place the original of the same orienta-
tion as the copy paper on the original
table.
tion as the copy paper on the original
table.
1.
Feeding direction
When you cannot place the original
as the above, you may not make cop-
ies as you want with particular func-
tions. If this happens, change the
orientation by selecting [
as the above, you may not make cop-
ies as you want with particular func-
tions. If this happens, change the
orientation by selecting [
]
or [
]
.
Note
❒ It is recommended that you use
this function together with the
Auto Paper Select or Preset Re-
duce/Enlarge function.
Auto Paper Select or Preset Re-
duce/Enlarge function.
AAAA
Press [Orientation/Custom].
BBBB
Select the original orientation,
and then press [OK].
and then press [OK].
ZEDH150E
AHD005S
DolphinC2_ENcopy_F_FM.book Page 16 Friday, February 25, 2005 10:46 AM