Gestetner ao80 Mode D’Emploi
Copying
38
2
Note
❒ Press [–0.1%] or [+0.1%] to ad-
just the ratio in 0.1% incre-
ments.
ments.
❒ If you make a mistake, press
[–1%]
, [–0.1%], [+0.1%] or
[+1%]
to readjust the ratio.
BBBB
Press [OK].
CCCC
Select the paper tray.
Size Magnification
This function calculates an enlarge-
ment or reduction ratio based on the
specified lengths of the original and
copy.
ment or reduction ratio based on the
specified lengths of the original and
copy.
Note
❒ Measure and specify the lengths of
the original and copy by compar-
ing "A" with "a".
ing "A" with "a".
AAAA
Press [Reduce / Enlarge].
BBBB
Press [Specifd. Ratio].
Make sure [Size Magnificatn] is high-
lighted.
Make sure [Size Magnificatn] is high-
lighted.
CCCC
Enter the length of the original
using the number keys, and then
press [#].
using the number keys, and then
press [#].
Note
❒ To change the size, press [Clear],
and then enter the new one.
❒ You can enter sizes within the
following ranges:
DDDD
Enter the length of the copy using
the number keys.
the number keys.
Note
❒ To change the size, press [Clear],
and then enter the new one.
EEEE
Press [#].
Note
❒ To change the length after press-
ing [#], select [Original] or [Copy],
and then enter the length again.
and then enter the length again.
FFFF
Press [OK].
GGGG
Select the paper tray.
ZEDG070E
Metric
version
version
1–9999 mm
(increments of 1 mm)
(increments of 1 mm)
Inch
version
version
0.1"–99.9"
(increments of 0.1")
(increments of 0.1")
DolphinC2_ENcopy_F_FM.book Page 38 Friday, February 25, 2005 10:46 AM