Gestetner dsc224 Mode D'Emploi

Remote Maintenance by telnet

105

Use the access command to view and configure access control. You can also
specify two or more access ranges.

❖

❖

❖

❖ Reference

❖

❖

❖

❖ Configuration

✩ range start-address end-address

•

✩ represents a target number between 1 and 5. (Up to five access ranges
can be registered and selected.)

Example: To specify accessible IP addresses between 192.168.0.10 and
192.168.0.20:
msh> access 1 range 192.168.0.10 192.168.0.20

❒ The access range restricts the workstations from which printing is possible

by means of an address. If you do not need to restrict printing, make the
setting “0.0.0.0”.

❒ The entry is invalid if the start address is greater than the end address.
❒ Up to five access ranges can be specified. The entry is invalid if the target

number is omitted.

❒ When using a Web Browser, telnet or SmartNetMonitor for Client/Admin,

you can use an IP address that has not been restricted by access control.
However, you cannot print from SmartNetMonitor for Client.

❖

❖

❖

❖ Access Control Initialization 

❒ This restores the factory-default settings so that all access ranges become

“0.0.0.0”.

Use the set command to configure the boot method.

msh> set parameter {on | off}

•  “on” means active and “off” means inactive.

❒ When you use DHCP, the server also needs to be configured.
❒ DHCP takes precedence over all other settings.

dhcp 

DHCP (Dynamic Host Configuration 
Protocol)