Gestetner dsc224 Mode D'Emploi

Appendix

130

Snmp over ipx is ready.

Communication over IPX with SNMP is avail-
able.

snmpd start.

SNMP service has started.

started.

Direct print service has started.

The print server received error <error 
number> during attempt to log in to the net-
work.Access to the network was denied.Verify 
that the print server name and password are 
correct. 

Cannot log in to the file server. The print serv-
er is not registered or the password is speci-
fied. Register the print server without 
specifying a password.

win2kspd protocol-DOWN (APPEXIT).

NVRAM setting ioctl (SPIO CAPPEXIT) of de-
vice SBP2TSP was set by protocol-DOWN.

SCSI print is not receiving data.

win2kspd protocol-UP (APPENTRY).

NVRAM setting ioctl (SPIO CAPPENTRY) of 
device SBP2TSP was set by protocol-UP.

SCSI print is not receiving data.

win2kspd started.

SCSI print (SBP-2) service has started.

WINS name refresh :Server No Response

There has been no response to the update re-
quest from the server. Confirm that the WINS 
server address is correct and the WINS server 
is working properly.

WINS name registration/refresh error 
code<error number>

Enter a different name. Confirm that the 
WINS server address is correct and the WINS 
server is working properly.

WINS name registration:Server No Response

There has been no response to the registration 
request from the server. Confirm that the 
WINS server address is correct and the WINS 
server is working properly.

WINS server address0.0.0.0

The WINS server address has not been speci-
fied. Specify the WINS server address to 
match the printer name with WINS.

WINS Server=< WINS server address > NetBI-
OS Name=<NetBIOS name>

The printer name has been successfully regis-
tered in <WINS server address>.

WINS wrong scopeID

The scope ID is wrong.

Specify the correct scope ID.

write error occurred. (diskfull)

The hard disk became full while the spool file 
was being written.

Wait until enough HDD space becomes avail-
able as printing proceeds.

write error occurred. (fatal)

A fatal error occurred while the spool file was 
being written.

Turn the printer off and then on. If this does 
not work, contact your service or sales repre-
sentative.