Gestetner dsc224 Mode D'Emploi
Configuring Protocols
49
4
Configuring a Windows NT computer
These steps are for configuring a Windows NT computer to use the TCP/IP pro-
tocol.
tocol.
AAAA
Open [Control Panel], and then double-click the [Network] icon. Make sure
that “TCP/IP Protocol” is listed in the [Network protocols] box on the [Proto-
cols]
that “TCP/IP Protocol” is listed in the [Network protocols] box on the [Proto-
cols]
tab.
Note
❒ If the TCP/IP protocol is not installed, click [Add] on the [Protocols] tab to
install it. For more information about installing the TCP/IP protocol, see
Windows NT Help.
Windows NT Help.
BBBB
Configure the TCP/IP protocols with the appropriate IP address, subnet
mask and other settings.
Check with the network administrator that the settings are correct.
mask and other settings.
Check with the network administrator that the settings are correct.
Configuring NetBEUI for Printing
Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.
dows NT to use the NetBEUI protocol.
Preparation
To use NetBEUI, use the SmartNetMonitor for Client port.
To use NetBEUI, use the SmartNetMonitor for Client port.
Configuring the machine
Configure the machine to use the NetBEUI protocol.
• Make sure that the NetBEUI protocol is set to active. (The default is active.)
• Make sure that the NetBEUI protocol is set to active. (The default is active.)
Reference
For more information about how to make the above settings, see the General
Settings Guide.
For more information about how to make the above settings, see the General
Settings Guide.