Gestetner dsc224 Mode D'Emploi
NetWare Configuration
72
5
Setting Up as a Remote Printer
AAAA
Log on to the file server as a Supervisor or a Supervisor equivalent.
Note
❒ When using NetWare 4.x, 5/5.1, log on to the file server as an administra-
tor or administrator equivalent.
BBBB
Run the NIB Setup Tool.
Reference
See p.60 “Running the NIB Setup Tool” .
See p.60 “Running the NIB Setup Tool” .
CCCC
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
DDDD
Click [IPX protocol].
EEEE
Click the IPX address of the Network Interface Board which is to be config-
ured, and then click [Next >].
ured, and then click [Next >].
Note
❒ If you do not know which Network Interface Board you are configuring,
see the network configuration page to check the MAC address (Network
Address).
Address).
FFFF
Make sure that the MAC address and IPX address are correct, and then click
[Finish]
[Finish]
.
The [NIB Setup Tool] window appears.
GGGG
Click [Configure].
The property sheet appears.
The property sheet appears.
HHHH
Click the [General] tab, and then type the name of the print server into the
[Device Name]
[Device Name]
box.
IIII
Click the [NetWare] tab, and then make the following settings.
NetWare 3.x
A In the [Print Server Name] box, type the name of the print server.
B In the [File Server Name] box, type the name of the file server in which a
B In the [File Server Name] box, type the name of the file server in which a
print server is to be created.
Clicking [Browse], you can select a file server among those listed in the
[Browse]
Clicking [Browse], you can select a file server among those listed in the
[Browse]
dialog box.