Gestetner dsc332 Mode D’Emploi
Clearing Z2 Misfeeds
2
When “Z2” Is Indicated (2)
If “Z2” is still indicated even though
you have gone through the steps in
“When “Z2” Is Indicated (1)”, follow
the procedure below to check for mis-
fed paper.
you have gone through the steps in
“When “Z2” Is Indicated (1)”, follow
the procedure below to check for mis-
fed paper.
AAAA
Turn off the power, and then un-
plug the power cable.
plug the power cable.
BBBB
Slowly open the front cover of the
machine, and remove the green
screwdriver.
machine, and remove the green
screwdriver.
Note
❒ There is a green screwdriver in-
side the front cover for use
when attaching the duplex feed
unit. By setting the top of the
screw into the screwdriver, you
can work without having to
wo r ry a bo u t d ro ppi n g t he
screw.
when attaching the duplex feed
unit. By setting the top of the
screw into the screwdriver, you
can work without having to
wo r ry a bo u t d ro ppi n g t he
screw.
CCCC
Carefully pivot the waste oil bot-
tle outward, in the direction of the
arrow.
tle outward, in the direction of the
arrow.
R CAUTION:
DDDD
With the screwdriver, remove the
screw holding the duplex feed
unit.
screw holding the duplex feed
unit.
You will need this screw when you
reattach the duplex feed unit.
reattach the duplex feed unit.
EEEE
Grip the upper left area of the du-
plex feed unit, and slowly pull it
halfway out.
plex feed unit, and slowly pull it
halfway out.
FFFF
Hold the duplex feed unit with
both hands, and slide it straight
out.
both hands, and slide it straight
out.
• Keep the waste oil bottle away
from flames. There is a risk of
fire or burns.
fire or burns.
ZJKY380J
ZHXH320J
ZJKY390J
ZJKY400J
JupC1_GB_Z2misfeed-F_FM.book Page 2 Monday, December 15, 2003 3:49 PM