Gestetner f540 Mode D’Emploi

187

10. Appendix

Installing, Moving, and Disposing of the
Machine

This section provides you with information about installation, move and dispos-
al of this machine.

Machine Environment

If the machine is installed in an inappropriate location, you may not be able to
make copies or send or receive fax messages properly. Doing so may also cause
the machine to malfunction.

R WARNING:

R CAUTION:

Note

❒ Install the machine on a level surface. Make sure that the difference in height

is less than 2 mm (0.08 in.) between the four corners of the machine.

❒ Install the machine on a stable surface. If you need to place it on a table, pre-

pare a sturdy table larger than the size of the machine exclusively for the ma-
chine.

❒ To avoid possible build-up of ozone, be sure to locate this machine in a large

well ventilated room that has an air turnover of more than 30 m

/hr/person.

• Connect the power cord directly into a wall outlet and never use an

extension cord.

• Turn off the power and disconnect the power plug (by pulling the

plug, not the cable) if any of the following occurs:

• You spill something into the machine.

• You suspect that your machine needs service or repair.

• The external housing of your machine has been damaged.

• Protect the machine from dampness or wet weather, such as rain and

snow.

• Do not allow paper clips, staples, or other small metallic objects to fall in-

side the machine.

StellaF25_EN_Combine_F_pre_FM.book Page 187 Thursday, August 26, 2004 8:45 PM