ONKYO HT-S5200 Manuel D’Utilisation
20
Note:
While speaker set B is on, speaker set A is reduced to
5.1-channel playback.
While speaker set B is on, speaker set A is reduced to
5.1-channel playback.
Connecting Speaker Set A
1
Strip 1/2"-5/8" (12-15
mm) of insulation from the
ends of the speaker cables.
(Supplied speaker cables
are already stripped.)
mm) of insulation from the
ends of the speaker cables.
(Supplied speaker cables
are already stripped.)
2
Unscrew the terminal. Fully insert the bare wire,
making sure that it’s touching the threaded shaft
in the center. Screw the terminal tight.
making sure that it’s touching the threaded shaft
in the center. Screw the terminal tight.
1/2"-5/8"(12-15mm)
Connecting Speaker Set B
1
Strip 3/8"-1/2" (10-12
mm) of insulation from the
ends of the speaker cables,
and twist the bare wires
tightly, as shown.
mm) of insulation from the
ends of the speaker cables,
and twist the bare wires
tightly, as shown.
2
While pressing the lever, insert
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
the wire into the hole, and then
release the lever.
Make sure that the terminals are
gripping the bare wires, not the
insulation.
3/8"-1/2"(10-12mm)
Surround
back left
speaker
Surround
back right
speaker
Front left
speaker
Front right
speaker
Center
speaker
Surround
right
speaker
Surround
left
speaker
The following illustration shows which speaker should be
connected to each pair of terminals.
If you’re using only one surround back speaker, connect it
to the left (L) SURR BACK SPEAKERS terminals.
connected to each pair of terminals.
If you’re using only one surround back speaker, connect it
to the left (L) SURR BACK SPEAKERS terminals.
Speaker Set A
Front left
speaker
Front right
speaker
Speaker Set B
Powered
subwoofer
HT-S5200_En.book 20 ページ ２００９年３月９日 月曜日 午後４時３１分