ONKYO TX-8222 Manuel D’Utilisation
10
Remote Controller
Point the remote controller toward the remote control
sensor.
sensor.
Notes:
• The remote controller may not work reliably if the
receiver is subjected to bright light, such as direct
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
sunlight or inverter-type fluorescent lights. Keep this
in mind when installing.
• If another remote controller of the same type is used
in the same room, or the receiver is installed close to
equipment that uses infrared rays, the remote
controller may not work reliably.
equipment that uses infrared rays, the remote
controller may not work reliably.
• Don’t put anything, such as a book, on the remote
controller, because the buttons may be pressed
inadvertently, thereby draining the batteries.
inadvertently, thereby draining the batteries.
• The remote controller may not work reliably if the
receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.
doors. Keep this in mind when installing.
• The remote controller will not work if there’s an obstacle
between it and the receiver’s remote control sensor.
8
1
6
7
7
5
2
4
3
K
J
S
U
L
9
T
Q
R
N
O
P
M
8
1
5
2
4
3
K
J
U
L
9
T
Q
R
N
O
P
M
TX-8522 North American model (RC-664S)
TX-8522 Other models (RC-665S)
TX-8222 All models (RC-666S)
TX-8222 All models (RC-666S)
* For the RC-666S, the names for the INPUT SELECTOR
buttons differ from the ones shown above.
buttons differ from the ones shown above.
*
Using the Remote Controller
Remote control sensor
About 5 m
(16 feet)
(16 feet)
TX-85228222_En.book 10 ページ ２００６年５月４日 木曜日 午前１１時５１分