ONKYO TX-NR801 Manuel D'Instructions

40

Enjoying Music or Videos with the TX-NR801/TX-NR801E—Continued

To change the individual speaker volumes temporarily, 
follow the procedure given below. Each channel can be 
set between –12 and +12 decibels (between –15 and 
+12 decibels for the subwoofer). Note that the speaker 
volumes will return to the original settings when the 
TX-NR801/TX-NR801E is put in the standby state.

Notes:
• You cannot select a speaker if it is set to “No” or 

“None” in the Speaker Config Sub-menu of the 
Speaker Setup Menu.

• To have your new speaker levels set here, overwrite 

the settings at Setup Menu 

→ Speaker Setup Menu 

→ Level Calibration Sub-menu, and press the TEST 
button after you complete step 3 in the procedure 
above.

With the sleep timer you can set the TX-NR801/
TX-NR801E so that it automatically turns off after a set 
period.

You can adjust the brightness of the front display of the 
TX-NR801/TX-NR801E using the DIMMER button on 
the remote controller or on the TX-NR801/TX-NR801E 
front panel (other than European models).

DSP

A-FO RM LISTENING MODE MEMORY

THX

SURROUND

DIRECT / PURE AUDIO

STEREO

FM MODE

MEMORY

ENTER

RE TURN

SETUP

TUNING

PRESET

Press the [SLEEP] button repeat-
edly to select the required sleep 
time.
You can set the sleep time from 90 to 10 
minutes in 10 minute increments.
The SLEEP indicator appears on the dis-
play when the sleep timer has been set, 
as shown. The specified sleep time 
appears on the display for about five sec-
onds, then the previous display reap-
pears.

To cancel the sleep timer, press the 
[SLEEP] button repeatedly until the 
SLEEP indicator disappears. 
To check the remaining sleep time, 
press the [SLEEP] button. Note that if 
you press the [SLEEP] button while the 
sleep time is being displayed, you’ll 
shorten the sleep time by 10 minutes.
Using the sleep timer only for Zone 2: 
If you are using the remote zone (Zone 
2), it will turn off at the same time as the 
main zone. If you want to set the sleep 
function for Zone 2 only, set the sleep 
function with main zone turned on and 
then put the main zone into the standby 
state.

DIMMER