ONKYO TX-SR800 Manuel D'Instructions

26

The 

 terminal on the TX-SR800 is for connecting other Onkyo

components equipped with the same 

 terminal. When a

component is connected to the 

 terminal, it can be operated by the

remote controller supplied with the TX-SR800. In addition, when
you connect a component to the 

 terminal, you can also perform

the system operations given below.

When the TX-SR800 is in the standby state, if an 

-connected

component is turned on, the TX-SR800 also turns on and the input
source selected at the TX-SR800 automatically switches to that
component.
Be aware that this function will not work if the power cord for the

-connected component is connected to the AC OUTLET on the

TX-SR800, or if the TX-SR800 has already been turned on.

When the play button is pressed at an 

-connected component, the

input source selected at the TX-SR800 automatically changes to that
component.

When the TX-SR800 is placed in the standby state, all 

-connected

components are also automatically put into the standby state.

Also, if you press the ON button on the TX-SR800 remote controller
while the TX-SR800 is turned on, all 

-connected components

(DVD players, CD players, MD recorders, tuners, etc.) are also
turned on.

To connect components using the 

 terminal, simply connect a

remote control cable from this 

 terminal to the 

 terminal of the

other component. An 

 remote control cable with a 1/8-inch (3.5-

mm) miniature two-conductor plug comes with every cassette tape
deck, compact disc player, MD recorder, and DVD player that has an

 terminal.

• When performing operations with 

-connected components

using the 

 system, do not use the remote zone (Zone 2).

• For remote control operation, the audio connection cables must

also be connected.

• If a component has two 

 terminals, you can use either one to

connect to the TX-SR800. The other one can be used to daisy
chain with another component.

• With Onkyo DVD players, you can enter the pre-program code

so that you can operate the DVD player directly with the remote
controller without connecting the 

 terminals (see page 65).

The TX-SR800 is equipped with AC mains outlets for connecting
the power cords from other devices so that their power is supplied
through the TX-SR800. By doing this, you can leave the connected
device turned on and have the STANDBY/ON button on the TX-
SR800 turn on and off the device together with the TX-SR800.

Caution:
Make sure that the total capacity of the components connected to the
TX-SR800 does not exceed the capacity that is printed on the rear
panel (e.g., TOTAL 120W).