Blaupunkt Acapulco MP52 Mode D’Emploi
8
➮
Press the
button
1
.
This unlatches the flip/release panel.
➮
First pull the flip/release panel
straight and then to the left out of
the unit.
straight and then to the left out of
the unit.
●
After removing the flip/release pan-
el, the unit switches itself off.
el, the unit switches itself off.
●
All the current settings are saved.
●
If there is a CD in the unit, it re-
mains there.
mains there.
Attaching the flip/release panel
➮
Slide the flip/release panel from left
to right into the unit guide.
to right into the unit guide.
➮
Press the left side of the panel into
the unit until it slots into place.
the unit until it slots into place.
Note:
●
Do not press against the display
while attaching the flip/release pan-
el.
while attaching the flip/release pan-
el.
If the device was still switched on when
you removed the control panel, it will
automatically switch on again with the
last settings activated (i.e. radio, CD, CD
changer/Compact Drive MP3 or AUX)
when the panel is replaced.
you removed the control panel, it will
automatically switch on again with the
last settings activated (i.e. radio, CD, CD
changer/Compact Drive MP3 or AUX)
when the panel is replaced.
Switching on/off
There are various ways of switching the
car radio on and off, as described be-
low.
car radio on and off, as described be-
low.
Switching on/off using the ignition
If the car radio is correctly connected to
the ignition and has not been switched
off using the button
the ignition and has not been switched
off using the button
3
, it is switched
on/off simultaneously with the ignition.
You can also switch on your car radio
when the vehicle ignition is off.
when the vehicle ignition is off.
➮
To do so, press the button
3
.
Note:
To protect the vehicle battery, the unit
switches off automatically after one
hour.
To protect the vehicle battery, the unit
switches off automatically after one
hour.
Switching on/off using the flip/
release panel
release panel
➮
Remove the flip/release panel.
The unit switches itself off.
➮
Replace the flip/release panel once
more.
more.
The car radio is switched on. The last
settings (radio, CD, CD changer/Com-
pact Drive MP3 or AUX) are activated.
settings (radio, CD, CD changer/Com-
pact Drive MP3 or AUX) are activated.
Switching on/off using the button
3
3
➮
To switch the unit on, press the but-
ton
ton
3
.
➮
To switch the unit off, hold the but-
ton
ton
3
down for more than two
seconds.
The car radio is now switched off.
FLIP/RELEASE PANEL
SWITCHING ON/OFF