Samsung mm-kt8 Manuel D'Instructions
14
13
CONNECTIONS
Connecting the FM and
AM(MW) Antennas
AM(MW) Antennas
FM antenna connection
AM
(MW)
antenna connection
1. Connect the FM antenna supplied to the FM 75Ω
COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you
find a location where reception is good, then
fasten it to a wall or other rigid surface.
fasten it to a wall or other rigid surface.
• If reception is poor, connect an outdoor antenna.
Before attaching a 75Ω coaxial cable (with a standard
type connector), disconnect the supplied FM antenna.
type connector), disconnect the supplied FM antenna.
1. Connect the AM loop antenna supplied
to the AM and terminals.
2. If reception is poor, connect an outdoor
single vinyl-covered wire to the AM
terminal. (Keep the AM loop antenna
connected).
terminal. (Keep the AM loop antenna
connected).
RADIO ANTENNA
If FM reception is poor,
connect an outdoor FM
connect an outdoor FM
antenna (not supplied).
FM Antenna (supplied)
AM Loop Antenna
(supplied)
(supplied)
Setting the Clock
For each step, you have a few seconds to set the required options.
If you exceed this time, you must start again.
If you exceed this time, you must start again.
•
You can display the time, even
when you are using another
function, by pressing
TIMER/CLOCK once.
when you are using another
function, by pressing
TIMER/CLOCK once.
•
CLOCK is displayed.
2
Press TIMER/CLOCK
twice.
twice.
1
Switch the system
on by pressing
POWER button.
on by pressing
POWER button.
•
"
TIMER" appears in the display.
•
The current time is now set.
5
When the correct
time is displayed,
press ENTER.
time is displayed,
press ENTER.
•
Increase the minutes :
•
Decrease the minutes :
4
When the correct
hour is displayed,
press ENTER.
The minutes flash.
hour is displayed,
press ENTER.
The minutes flash.
•
Increase the hours :
•
Decrease the hours :
3
Press ENTER.
The hour flashes.
The hour flashes.
Note
Checking the Remaining Time
CHAPTER REMAIN
TITLE REMAIN
CHAPTER ELAPSED
TITLE ELAPSED
TRACK REMAIN
TOTAL ELAPSED
TOTAL REMAIN
TRACK ELAPSED
Each time the REMAIN button is pressed
Press the REMAIN button.
•
For checking the total and remaining time of a title or chapter being played.
DVD
CD
VCD
•
By default, the video format is set to "PAL".
•
"NTSC" and "PAL" will appear in the display.
At this time,press the NT/PAL button shortly to select between “NTSC” and “PAL”.
•
Each country has a different video format standard.
•
For normal playback, the video format of the disc must be the same as the video format of your TV.
Turn off the main unit and then press and hold NT/PAL button on the remote controller for over 5 seconds
.
Selecting the Video Format