EQD EQ1988 Mode D'Emploi
2
WALL-MOUNT INSTRUCTION
Preparing To Install The Optional Wall Mount Arm (not included)
This TV can be attached to a wall mounting arm you can purchase separately.
Turn the power OFF then disconnect the cables from the
Turn the power OFF then disconnect the cables from the
TV
before performing the procedure
below.
1. Place the TV face down on a soft cloth or cushion on a table.
2. Remove the base.
3. Remove the 4 screws holding the stand to the hinge.
4. Remove the stand.
1. Place the TV face down on a soft cloth or cushion on a table.
2. Remove the base.
3. Remove the 4 screws holding the stand to the hinge.
4. Remove the stand.
Attaching The Optional Wall Mount Arm (not supplied)
Follow these steps to finish installing the wall mounting arm:
1. Place the wall mounting arm onto the back of the TV. Line up the holes of the arm with the
1. Place the wall mounting arm onto the back of the TV. Line up the holes of the arm with the
holes in the back of the monitor.
2. Insert the 4 screws into the holes and tighten.
3. Reconnect the cables. Refer to the user’s manual that came with the optional wall mounting
3. Reconnect the cables. Refer to the user’s manual that came with the optional wall mounting
arm for instructions on attaching it to the wall.
NOTE
100 x 100mm VESA high hole (n=4), M4, pitch =0.7 mm screw mounting kit not included.
Due to safety concerns, if the VESA mounting kit is purchased separately please make sure the
mounting kit is UL-Listed, and replaceable only by service personnel.
mounting kit is UL-Listed, and replaceable only by service personnel.
E
ng
lis
h