GVision p10ps-j Mode D'Emploi
Setting Up
WARNING When you disconnect the cord/cables, be sure to hold the connector instead
of the wire part.
of the wire part.
Analog / Video-in Model:
Touch Screen Model:
1. Connect one end of the power adapter to the monitor and the other end to the connector
of the power cord. ( )
2. Connect one end of the signal cable to the rear side of computer and the other to the LCD
monitor. Tighten by turning clockwise the two thumb screws to ensure proper grounding.
( )
( )
3. Connect either end of the video-in (S) cable to the connector on the monitor and the other
end to the video-out connector of your accessory. ( ) (optional module)
4. Connect either end of the video-in (RCA) cable to the connector on the monitor and the
other end to the video-out connector of your accessory. ( ) (optional module)
5. Connect either end of the audio cable to the audio in connector on the monitor and the
other end to the audio-out connector of your computer. ( ) (optional module)
6. Pressing
the
power button on front panel turns the display system power on. ( )
7. Connect one end of the touch (RS232) cable to the rear side of computer and the other to
the LCD monitor. Tighten by turning clockwise the two thumb screws to ensure proper
grounding. ( ) (optional module)
grounding. ( ) (optional module)
7