Belkin F1DP108A Mode D'Emploi
37
se
ct
io
n
1
2
3
4
5
6
7
8
Using Your SMB CAT5 KVM Switch
Using Your SMB CAT5 KVM Switch
Using Your SMB CAT5 KVM Switch
Timeout
This specifies the amount of time that can elapse before the administrator will
be locked out of the KVM Switch (and connected servers) due to user inactivity.
To regain access to the KVM Switch after Timeout, simply reenter the Admin
Password in the login box. The Timeout feature is only available if the Security
feature is enabled. You may set the time intervals to anywhere between 1 and
99 minutes. To change the time interval, use the arrow keys to navigate, type
the desired time interval, and press “Enter” to save the entry. If you disable the
Security feature, the Timeout feature will be turned off automatically.
NOTE: If there are secondary KVM switches connected, and the AutoScan time
be locked out of the KVM Switch (and connected servers) due to user inactivity.
To regain access to the KVM Switch after Timeout, simply reenter the Admin
Password in the login box. The Timeout feature is only available if the Security
feature is enabled. You may set the time intervals to anywhere between 1 and
99 minutes. To change the time interval, use the arrow keys to navigate, type
the desired time interval, and press “Enter” to save the entry. If you disable the
Security feature, the Timeout feature will be turned off automatically.
NOTE: If there are secondary KVM switches connected, and the AutoScan time
and Timeout settings are set on the primary KVM switch, the settings will also
apply to all secondary KVM switches.
Monitor-DDC2 Feature
This feature allows the console monitor to inform the server’s video card about
its properties, such as maximum resolution and color depth. The video card will
then adjust the monitor’s settings accordingly. This enables your monitor to use
its optimal settings for every server connected to your SMB CAT5 KVM Switch.
To read the DDC2 information from the monitor and program it to all connected
Server Interface Modules, press “F10”. Every time you change the monitor, you
will need to press “F10” again to program the new DDC information to the Server
Interface Modules.
its properties, such as maximum resolution and color depth. The video card will
then adjust the monitor’s settings accordingly. This enables your monitor to use
its optimal settings for every server connected to your SMB CAT5 KVM Switch.
To read the DDC2 information from the monitor and program it to all connected
Server Interface Modules, press “F10”. Every time you change the monitor, you
will need to press “F10” again to program the new DDC information to the Server
Interface Modules.