Infocus lp760 Manuel D’Utilisation

LitePro 760 User’s Guide

Connecting the LitePro 760

This chapter describes how to position the LitePro for optimum
viewing and how to connect it to your computer.

Setting Up

1. Place the projector on a flat surface.

• The projector must be within 6 feet of your power source.

• The projector must be within 6 feet of the computer.

• If you are installing the projector on the ceiling, refer to the

Ceiling Mount Installation Guide for recommendations. (The
Ceiling Mount Kit is sold separately.)

• For information about projector placement and image size, see

the “LitePro Tips” box on the next page.

2. Orient the projector so that its lens faces the projection screen.

• If you want to use the LitePro’s Rear Project feature, set it up

behind your translucent screen. Refer to “Rear Projection” on
page 23 for more information.

3. If the projection lamps have not been installed in the projector

4. Remove the lens cover.

5. Plug the power cord into the projector, then plug it into your elec-

trical outlet.

• While the cord is connected, you can switch the projection

lamp off by pressing the

standby

button on the remote. The

lamp turns off to conserve electricity.

Always use the power cord that was shipped with your LitePro 760.

The projector accepts power from 100 VAC and 220 VAC, 50 or 60

Hz, three-wire type grounded sources. When you disconnect the

projector, always remove the power cord from the electrical outlet

first, then from the projector.

Osprey.bk Page 5 Monday, December 11, 2000 1:38 PM