Infocus lp760 Manuel D’Utilisation

Follow this procedure if your computer is a Sun SPARCstation, SGI 
Indigo or Indy, Intergraph 2400 or 6400, or color NeXTstation.

1. Locate your monitor cable; it connects the monitor to the com-

puter. Unplug it from the computer. Remember where you 
unplugged the cable from the computer, you will plug the 
LitePro cable into this same connector in the next step.

2. Attach one of the 13W3 adapters to the “Computer” end of the 

LitePro cable. 

• If your computer is an SGI, plug the “SGI” end of the adapter 

into the “Computer” end of the LitePro cable. For other 
computers, use the “Other” connector.

3. Plug the adapter (with the cable attached) into the monitor con-

nector on the computer. 

4. Attach the other 13W3 adapter to the “Monitor” end of the 

LitePro cable. 

• If your computer is an SGI, plug the “SGI” end of the adapter 

into the “Monitor” end of the LitePro cable. For other 
computers, use the “Other” connector.

5. Plug the adapter (with the cable attached) into the computer’s 

monitor cable.

6. Tighten the thumb screws on all the connectors to ensure proper 

grounding.

7. Turn on the monitor. 

8. Turn on the LitePro 760 by pressing the “1” side of the power 

switch. (Refer to “Powering Up the LitePro” on page 15.)

9. Turn on the computer.

Osprey.bk  Page 8  Monday, December 11, 2000  1:38 PM