ICOM ic-207h Manuel D'Instructions
D Frequency range and offset direction
5
REPEATER OPERATION
28
■ Auto repeater
(U.S.A. version only)
The U.S.A. version automatically activates the repeater set-
tings (DUP or DUP– and tone encoder ON/OFF) when the
operating frequency falls within the general repeater output
frequency range and deactivates them when outside of the
range.
tings (DUP or DUP– and tone encoder ON/OFF) when the
operating frequency falls within the general repeater output
frequency range and deactivates them when outside of the
range.
D Setting the auto repeater function ON/OFF
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET] (far right switch), turn power ON to
enter initial set mode.
enter initial set mode.
➂
Push [SET] one or more times until the “rPt” display ap-
pears as shown below.
pears as shown below.
➃
Rotate the tuning dial to turn the auto repeater function to
“r1,” “r2” or OFF.
“r1,” “r2” or OFF.
• “r1”: auto repeater is ON, tone encoder is OFF;
“r2”: auto repeater is ON, tone encoder is ON.
➄
Push [PWR] momentarily to exit initial set mode.
USING
INITIAL SET MODE
FREQUENCY RANGE
DUPLEX DIRECTION
145.200–145.495 MHz
146.610–146.995 MHz
146.610–146.995 MHz
“DUP–” appears
147.000–147.395 MHz
“DUP” appears
442.000–444.995 MHz
“DUP” appears
447.000–449.995 MHz
“DUP–” appears
T
DUP
Auto repeater function is
turned OFF
turned OFF
Auto repeater function is ON,
tone encoder is OFF.
tone encoder is OFF.