Behringer eg2180 Mode D'Emploi

EUROGRAND

Advanced operation

The memory of the music sequencer can store up to

10,000 notes. However, this number can decrease de-

pending on how much pedaling information is stored.

You can quit record mode by pressing the REC button

again.
Press the TRACK button of the track you want to record

until the REC LED above the button lights up red. Now the

selected track is record-ready. If you did a recording take

before, the last track selected will be used for recording.

Depending on which track is currently used, you will have

to select the other track for recording.

Tip: If you select a track for recording, which already

contains note information, all previously recorded notes

on this track will be erased!
Select a sound in the SOUND SELECT section. You can also

use a sound combination (see chapter 4.1) for recording.

Switch on the acoustic metronome signal by pressing the

METRONOME button, if you want to make a metronome-

backed recording.

Start recording by pressing the START/STOP button or

simply start playing on the keyboard. The current meter is

constantly shown in the display.

If the display starts flashing during recording and reads

the message FUL, this is to warn you that the recording

memory has been used up. All data recorded up to this

point will be stored, however, but recording process

will be terminated.
Once your recording is finished stop the sequencer by press-

ing the START/STOP button again.

Recording mode will thus be canceled automatically.

Playing back pieces of music

5.5.3

This section describes how to play back the music piece you

have just recorded.

Press the TRACK 1 and TRACK 2 buttons until the green

PLAY LED above the buttons lights up. This is to activate

the tracks for recording.

You can only activate those tracks for playback which

actually contain note information.
If you want to have a metronome-backed playback, press the

METRONOME button to switch on the metronome.

Press the SELECT button in the TEMPO/EDIT MODE sec-

tion until the TEMPO LED lights up, then use the two < >

buttons to adjust the playback tempo.

You can play back a recording at its original tempo by

pressing the two < > buttons at the same time.
Press the START/STOP button to play back the recording.

The current meter is constantly shown in the display.

During playback the two tracks can be switched on/off

at any time.

You can accompany the music sequencer playback with

the currently selected sound.

TIP: If the right-hand part has been recorded on track

2 and the left-hand part on track 1, you can switch off

either of the tracks and practice its part live during

playback. The volume of the muted track is adjustable.

If necessary you can play it back in the background at

low volume for support (see chapter 5.5.5).
To stop the playback, press the START/STOP button

again.