Behringer eg2180 Mode D'Emploi
EUROGRAND
Advanced operation
11
Transposition
5.3.3
Use this function to transpose the selected sounds up or down
by one octave. Depending on which sounds are used in a com-
bination, the tranpose function can help make the sounds more
homogeneous.
Example:
In a combination of GRAND PIANO 1 and STRINGS the STRINGS
Example:
In a combination of GRAND PIANO 1 and STRINGS the STRINGS
sound too low. In this case, it helps to transpose the STRINGS
up by one octave.
Please enter EDIT mode (see chapter 5.1) and select the
+
following function.
Function:
E3.3
(voice #1 transposed by an octave)
E3.4
(voice #2 transposed by an octave)
Value:
-1 ... 1
Description:
0:
No transposition
-1:
Transposition down by one octave
1:
Transposition up by one octave
Effect intensity
5.3.4
This function allows you to edit the effect intensity of the modula-
tion effect for the selected sounds.
Please enter EDIT mode (see chapter 5.1) and select the
+
following function.
Function:
E3.5
(effect intensity voice #1)
E3.6
(effect intensity voice #2)
Value:
0 ... 20
Description:
1 ... 20:
Effect intensity (default setting)
0:
No effect
Reset
5.3.5
Use this function to reset all settings in layer mode.
Please enter EDIT mode (see chapter 5.1) and select the
+
following function.
Function:
E3.7
Value:
-
Description:
Press the +/YES button to execute this function.
Press the +/YES button to execute this function.
Using the metronome
5.4
The EUROGRAND features a built-in metronome which can be
used for practising or to make recordings with the internal music
sequencer.
To use the metronome, please proceed as follows :
To use the metronome, please proceed as follows :
Press the METRONOME button to start or stop the met-
1)
ronome.
The metronome beats are shown by flashing dots on the display.
At the beginning of a measure all dots light up simultaneously.
Keep pressing the SELECT button in the TEMPO/EDIT
2)
MODE section until the TEMPO LED lights up.
Use the two
3)
< >
buttons to adjust a tempo of your
choice.
Press and hold the METRONOME button while adjusting
4)
the number of beats per measure using the -/NO and +/YES
button in the VALUE/SONG section.
+
The display reads:
04:
No stressed beats (default setting)
24, 34, 44, 54, 64, 74:
Quarter meter (e. g. 2/4)
38, 68, 78, 98, 128:
Eighth-note meter (e. g. 3/8)
Metronome volume
5.4.1
Use this function to adjust the metronome volume.
Please enter EDIT mode (see chapter 5.1) and select the
+
following function.
Function:
E5
Value:
1 ... 20
Description:
1 ... 20:
Metronome volume (1 = low, 20 = high)
Proceed as follows for direct access to the metronome volume
menu page.
Press and hold the METRONOME button, then hit the SE-
1)
LECT button in the TEMPO/EDIT MODE section.
+
The EDIT MODE LED lights up and the EDIT page E5 is dis-
played.