TOA cs-64u Mode D'Emploi
Printed in Indonesia
5 3 3 - 0 6 - 1 1 0 - 5 0
5 3 3 - 0 6 - 1 1 0 - 5 0
5. IMPEDANCE CHANGE
The input impedance is factory-preset to 1.7 k
Ω.
To change the impedance, change the rear
panel-mounted rotary switch position to the
desired impedance (wattage) using a standard
screwdriver.
panel-mounted rotary switch position to the
desired impedance (wattage) using a standard
screwdriver.
Notes
• This speaker is designed to operate on a 70 V
• This speaker is designed to operate on a 70 V
or 100 V line. Do not connect it to the
amplifier's low impedance line.
amplifier's low impedance line.
• No sound is output when the switch is set to
the OFF position.
Caution
Never set the switch to "–" position for 100 V
line operation, as doing so may result in damage
to the speaker.
Never set the switch to "–" position for 100 V
line operation, as doing so may result in damage
to the speaker.
8. SPECIFICATIONS
* Impedance for 70 V line
Note
The design and specifications are subject to
change without notice for improvement.
The design and specifications are subject to
change without notice for improvement.
Speaker Component
12 cm cone speaker
Rated Input
6 W
Impedance
(830
Ω)*, 1.7 kΩ, 3.3 kΩ, 10 kΩ
Frequency Response
130 – 13,000 Hz
Sensitivity
96 dB (1 W, 1 m)
Finish
Body
ABS resin, off-white, paint
Bracket
Stainless steel
Net
Zinc-coated steel, gray, paint
Dimensions
233 (w) x 224 (h) x 208 (d) mm
Weight
1.5 kg
Line Voltage
Imp.
70 V
100 V
6 W
–
830
Ω
3 W
6 W
1.7 k
Ω
1.5 W
3 W
3.3 k
Ω
0.5 W
1 W
10 k
Ω
← Factory-preset values
OFF
OFF
1W
3W
6W
100V
0.7W
1.5W
3W
6W
70V
10k
Ω
3.3k
Ω
1.7k
Ω
830
Ω
IMP.
LINE VOLTAGE
Wa
ll surface
Ceiling
surface
• Be sure to direct the speaker
down towards the ground.
Otherwise, rain floods the
speaker, causing its failure.
Otherwise, rain floods the
speaker, causing its failure.
• No mounting hardware such as
bolts and nuts is supplied with
the speaker.
Use commercial mounting
hardware appropriate for the
installation environment.
the speaker.
Use commercial mounting
hardware appropriate for the
installation environment.
• Please install only with either
flexible conduit or flexible
wiring.
wiring.
7. INSTALLATION
[Mounting on the Wall]
[Mounting under the Eaves
or on the Ceiling]
6. CONNECTION
Make the connections using marrets (wire nuts)
inside a UL Listed junction box.
inside a UL Listed junction box.
Note
This product shall be installed in accordance with
the National Electrical Code, ANSI/NFPA 70.
This product shall be installed in accordance with
the National Electrical Code, ANSI/NFPA 70.
UL Listed Junction Box
(–)
(–)
(+)
(+)
Marrets (wire nuts)
From Speaker
From Amplifier