Epson DFX-9000 Guide De Référence

2

2

2

2

2

2

2

2

2

2

2

The top-of-form position is the position to which the printer 
feeds the paper when it loads it or performs a form feed. This 
position is important because it determines where the printing 
begins on each page. If the printing is too high or low on the 
page, you can adjust the top-of-form position either 
permanently or temporarily depending on how you use the Top 
of Form button.

❏ When you want to permanently change the top-of-form 

position, you enter the top-of-form mode using the Top of 
Form control panel button. The printer remembers the new 
top-of-form position even after the printer is turned off, 
reset, or initialized. (The printer remembers separate 
top-of-form positions for the front and rear tractors.)

❏ When you want to temporarily change the top-of-form 

position, you adjust the position using the Micro Feed 
buttons without entering top-of-form mode. The printer 
remembers the temporary top-of-form position until the 
next time you load paper, switch tractors, or turn off the 
printer. 

You can set the top-of-form position from 4.2 mm (0.17 inch) to 
33.9 mm (1.33 inch) below the top edge of the paper. The default 
setting is 8.5 mm (0.33 inch).

Follow the steps below to reset (permanently change) the 
top-of-form position.

c

Caution:
To adjust the top-of-form position when you are printing on 
labels, continuous forms with labels, or overlapping multi-part 
forms, use the Micro Feedu button only; do not enter the 
top-of-form mode. Never feed labels backward through the 
printer.