Epson DFX-9000 Mode D'Emploi

Read all of these safety instructions before using the printer. In addition, follow all 
warnings and instructions marked on the printer itself.

❏

Do not place the printer on an unstable surface or near a radiator or heat 
source.

❏

Place the printer on a flat surface. It will not operate properly if it is tilted or 
placed at an angle.

❏

Do not block or cover the slots and openings in the printer’s cabinet, and do 
not insert objects through the slots.

❏

Use only the type of power source indicated on the printer’s label.

❏

Connect all equipment to properly grounded electrical outlets. Avoid using 
outlets on the same circuit as photocopiers or air control systems that regularly 
switch on and off.

❏

Do not use a damaged or frayed power cord.

❏

If you use an extension cord with the printer, make sure the total ampere rating 
of all devices plugged into the extension cord does not exceed the cord’s ampere 
rating. Also, make sure the total ampere of all devices plugged into the electrical 
outlet does not exceed the electrical outlet’s ampere rating.

❏

Unplug the printer before cleaning it, and clean it with a damp cloth only.

❏

Do not spill liquid onto the printer.

❏

Except as specifically explained in the user documentation, do not attempt to 
service the printer yourself.

❏

Never replace the print head yourself; you may damage the printer. Also, other 
parts of the printer must be checked when the print head is replaced.

❏

You need to move the print head by hand to replace the ribbon cartridge. If 
you have just used the printer, the print head may be hot; let it cool for a few 
minutes before touching it.

❏

Adjust only those controls that are covered by the operating instructions.

❏

Unplug the printer and refer servicing to qualified service personnel under 
the following conditions: if the power cord or plug is damaged, if liquid has 
entered the printer, if the printer has been dropped or damaged, if it does not 
operate normally or exhibits a distinct change in performance. 

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio or television reception. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does 
cause interference to radio and television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures.

❏

Reorient or relocate the receiving antenna.

❏

Increase the separation between the equipment and receiver.

❏

Connect the equipment into an outlet on a circuit different from that to which 
the receiver is connected.

❏

Consult the dealer or an experienced radio/TV technician for help.

The connection of a non-shielded equipment interface cable to this equipment will 
invalidate the FCC Certification of this device and may cause interference levels 
which exceed the limits established by the FCC for this equipment. It is the 
responsibility of the user to obtain and use a shielded equipment interface cable with 
this device. If this equipment has more than one interface connector, do not leave 
cables connected to unused interfaces.

Changes or modifications not expressly approved by the manufacturer could void 
the user’s authority to operate the equipment.

This Class B digital apparatus meets all requirements of the Canadian Interface 
Causing Equipment Regulations.

K

This symbol is placed on the print head and other parts to indicate that 
they may be hot. Never touch those parts just after the printer has been 
used. Let them cool for a few minutes before touching them.